| Worktable diameter | mm | Ø210 | ||
|---|---|---|---|---|
| Center bore diameter | mm | Ø65H7 | ||
| Through- hole diameter | mm | Ø65 | ||
| Height of table (horizontal) | mm | 175 | ||
| Height of center (vertical) | mm | 160 | ||
| Width of T-slot | mm | 12H7 | ||
| Width of guide block | mm | 18 | ||
| Drive pressure / method | MPa | 0.5-0.7/Pneumatic | ||
| 2.5/Hydraulic | ||||
| Clamping torque | N.m | 400 (600/Hydraulic) | ||
| Servo motor type | Fanuc | α4i | ||
| Mitsubishi | HF-54T | |||
| Transmission ratio | 1 / 72 | |||
| Max. table speed | min-1 | 53.3 | ||
| Allowable loading inertia |  |
Kg.m2 | 1.38 | |
| Resolution | deg. | 0.001 | ||
| Indexing accuracy | sec. | 20 | ||
| Repeatability | sec. | 6 | ||
| Net weight (servo motor excluded) | Kg | 60 | ||
| Allowable loading capacity | Vertical | Kg | 125 | |
| Horizontal | Kg | 250 | ||
| Tailstock applied | Kg | 250 | ||
| Allowable load (when table clamped) | F |  |
N | 17000 |
| FXL |  |
N.m | 1265 | |
| FXL |  |
N.m | 400 (600/Hydraulic) | |
| Allowable wheel torque |  |
N.m | 260 |
